Rhino dachträger. Wilkommen

Wilkommen

rhino dachträger

Now that we've gone over some of the features of the roof rack system let's go ahead and show you how it installs. We'll push it in, turn the key, do this on both side, and then we're ready to load up our accessories and hit the road. We'll start by installing our pad by just pushing it into place. We have the rear bar partially assembled on our table here, and we'll finish up by applying our fit kit to our other leg. This comes with everything including the fit kit for your specific vehicle. It does have the Vortex Aero strips up at the top, and that combined with the aerodynamic shape of the bar will cut down wind noise and drag while you're driving. Once it's installed now we can put this on the roof of our vehicle.

Next

Rhino

rhino dachträger

Unscrew that, push our clamp into place, put our screw back through, and just loosely install it so the clamp will stay in. Once they're both measured out we can start tightening them down with the included tightening tool. You want to make sure that the arrow is facing the proper direction, and that the number of the pad corresponds with the proper foot. The two bars have a combined carrying capacity of 165 pounds, but you always want to double check with your vehicle's manual to make sure your roof can withstand that weight. Next we'll get our cross bar spread measure from center to center, you'll find this measurement in your instructions, and we'll do this on both sides. It does get a little confusing. All four end cap legs are lockable, so once this is installed onto your roof, it's secure to your roof as well.

Next

Rhino

rhino dachträger

The way you know that is that the tool here actually has a curved end to it, once that straightens out as you tighten down you know it's torqued to its specifications, and you won't over-tighten it. We'll start with the rubber pad first. . Our final step is to put our locking end cap into place. We'll start by getting it snug up against the door, and then we'll give it about five or six turns on each side until they're completely tightened down. Then we'll install our clamp on the end.

Next

Gobi Racks

rhino dachträger

. . . . . . .

Next

etrailer

rhino dachträger

. . . . . .

Next

Wilkommen

rhino dachträger

. . . . .

Next

Gobi Racks

rhino dachträger

. . . . . .

Next